top of page
Search

Introducing the Tapestry Presence, Temperature & Humidity Sensor

Hey everyone, welcome back to Bud's Smart Home! Today, we're introducing a fantastic new addition to your smart home setup: the Tapestry Presence, Temperature & Humidity Sensor. Tapestry Presence Sensor Z1 was designed and assembled right here in the USA.



This is a state-of-the-art device that uses a 60GHz millimeter wave radar and a sophisticated machine learning algorithm to accurately detect room occupancy, even when occupants are sitting still. It can sense even the smallest movements, ensuring your smart home system responds precisely and effortlessly.

Want to read more?

Subscribe to budshomeautomation.com to keep reading this exclusive post.

3 Comments

Rated 0 out of 5 stars.
No ratings yet
Add a rating
ivan
Jun 16
Rated 5 out of 5 stars.

Your video was great. it convinced me join your site and pay the $10. i then purchased the Z1. i positioned it in my living room facing the couch. ST shows active when i am in range. so far so good. then i created a routine. Between hours of 715pm and 11pm, turn on the lights when presence is detected. this works fine. However, if i sit down early (say 645pm), the lights don't turn on at 715pm. i think this might be a ST bug or feature issue. The ST routine will only acknowlege me if it becomes "active" after 715pm. In summary, it was active at 645pm onward, and did not initiate at 715pm. any ideas?

Like
Bud
Bud
Jun 16
Replying to

OK, Ivan, I looked at your expanded question on the spaces app. I’m not sure how you have your SmartThings routine set up, but I would suggest placing the detection of presence as a precondition statement. Therefore it would read if presence is detected, precondition, and the time is between X and Y, then turn lights on. If that doesn’t work, I’ll need to contact tapestry or you can reach out to them. If you wish to see what the frequency of pulling is on the sensor. Let me know if I could be a more assistance.

Like
bottom of page